wireless mode

wireless mode#

Note

Only suitable for scanners that support 2.4G transmission.

Read Interface Settings#

../../_shared/_images/wireless-rf-bt/2523IFSNO24.png

Current Interface Settings#

Wireless transmission method#

Note

The blue light is always on or flashing to indicate that it is currently in Bluetooth mode; the blue light is off to indicate that it is currently in 2.4G mode or USB wired mode.

../../_shared/_images/wireless-rf-bt/2523IFSNO241.png

2.4G transmission mode#

2.4G pairing#

Important

Only valid in wireless 2.4G mode.

../../_shared/_images/wireless-rf-bt/24RF23CH025.png

Start 2.4G pairing#

../../_shared/_images/wireless-rf-bt/24RF23CH02.png

one-to-one pairing#

../../_shared/_images/wireless-rf-bt/24RF23CH024.png

One-to-one pairing#

Receiver working mode#

Note

Composite device mode is only available on receivers running FWVerL or later. You can also use ReceiverAddress.exe to generate a pairing barcode and complete pairing by scanning it.

../../_shared/_images/wireless-rf-bt/24USB23KEYM.png

Receiver as composite device#

../../_shared/_images/wireless-rf-bt/24USB23COM.png

Receiver as virtual serial port#

Note

This mode requires the virtual serial port driver to be installed.

../../_shared/_images/wireless-rf-bt/24USB23KEY.png

receiver as keyboard#

Receiver keyboard transmission speed#

Note

The instructions in this section are only applicable to receivers of FWVerL and above. The transmission speeds of the scanner and receiver must match, otherwise errors may occur when transmitting long barcodes.

Important

This command is only valid in wireless 2.4G mode and the receiver is connected normally.

../../_shared/_images/wireless-rf-bt/25KB23SP.png

Read keyboard speed#

Example

KB SP=2,4 represents a USB keyboard speed of 2ms and a receiver keyboard speed of 4ms.

../../_shared/_images/wireless-rf-bt/24USB23KEY-2.png

receiver keyboard high speed#

../../_shared/_images/wireless-rf-bt/24USB23KEY4.png

Receiver Keyboard Medium Speed#

../../_shared/_images/wireless-rf-bt/24USB23KEY9.png

Receiver Keyboard Low Speed#

Note

It is only valid in wireless 2.4G mode and the receiving end receives normally.

2.4G transmission cache#

Note

This command is only available on some scanners that support this feature. After scanning the setup code, two short beeps indicate disabled, and one three-tone beep indicates enabled.

When scanning ordinary barcodes, if the amount of barcode data is large and the scanning interval is short, and the data is not uploaded in time, you can use this setting barcode to turn on or off data caching.

../../_shared/_images/wireless-rf-bt/25KB23SPFF.png

SRAM cache switch#

In normal mode, after data caching is turned on, if the device briefly leaves the communication distance and enters offline state, you can use this setting to choose to wait for connection before uploading the cached data, or to clear the cached data.

../../_shared/_images/wireless-rf-bt/25KB23SPFC.png

Offline caching switch#